Overview on Analysis of Machine Element Failure using Solidworks

Authors

  • Awatade R. S. Student, Department of Mechanical Engineering, Sahakar Maharshi Shankarrao Mohite Patil Institute of Technology and Research, Akluj, Maharashtra Author
  • Magar R. R. Student, Department of Mechanical Engineering, Sahakar Maharshi Shankarrao Mohite Patil Institute of Technology and Research, Akluj, Maharashtra Author
  • Devkule D. N. Student, Department of Mechanical Engineering, Sahakar Maharshi Shankarrao Mohite Patil Institute of Technology and Research, Akluj, Maharashtra Author
  • Kothawale S. M. Student, Department of Mechanical Engineering, Sahakar Maharshi Shankarrao Mohite Patil Institute of Technology and Research, Akluj, Maharashtra Author
  • Shete Y. S. Lecturer, Department of Mechanical Engineering, Sahakar Maharshi Shankarrao Mohite Patil Institute of Technology and Research, Akluj, Maharashtra Author

DOI:

https://doi.org/10.29070/k04d0a38

Keywords:

Design, Simulation, Modelling, Solid Works, Failure Analysis

Abstract

Uses of computer application in engineering design become a very common now a day. It isvery obvious to use the different software for performing design operations in various sectors. There arefew much popular software are available such as AutoCAD, PTC Creo, Ansys, Solidworks, SolidModelling and so all. In this paper, author has been focused on the design and analysis of the enginecomponent using Solidworks. Solidworks is one of the most trending software now a day. This softwareallows design as well as simulation and Modelling by itself. The aim of this paper is to discuss theprocedure for modelling different kind of shapes and their analysis.

Downloads

Download data is not yet available.

References

F. Ashida, T. R. (1998). Tauchert An inverse problem for determination of transient surface temperature from piezoelectric sensor measurement Journal of Applied Mechanics, 65 (2), pp. 367-373 [doi:10.1115/1. 2789064].

P.R. Barrett, H. Foadian, R.J. James, Y.R. Rashid (1992). Thermal-structural analysis methods for RCC dams Proceedings of the Conference of Roller Concrete III, ASCE, San Diego, pp. 407-422.

L.J. Liu, J.P. Ren (2005). “Application of the secondary development in SolidWorks”, Mechanical Management and Development (1), pp. 74-75.

J. Zhang (2005). “Interface design between AutoCAD and ANSYS”, Chinese Quarterly of Mechanics, 26 (2), pp. 257-262.

B.F. Zhu, P. Xu (2001). ‘Methods for stress analysis simulating the construction process of high concrete dams”, Dam Engineering, 6 (4), pp. 243-260.

Downloads

Published

2022-03-01

Issue

Vol. 19 No. 1 (2022): Journal of Advances in Science and Technology (JAST)

Section

Articles